Finished PowerBraces and BrightWall
This photo is showing an area where we installed water control in the floor, BrightWall (the white sheet on the wall) and PowerBraces.
Installed SuperSump
In the corner of the basement, we installed our SuperSump system. This system houses a Zoeller 1/3 hp cast iron pump, a WaterWatch alarm which alerts you if the water level rises in the sump crock and an airtight lid.
After the Installation
You can see here that the PowerBraces are secured to the floor and connect to the floor joists above. The design of the upper bracket allows the braces to be tightened against the wall.
After the Installation
In this picture you can see that the new concrete has been poured over the area of the floor that was removed to install the water control system. On the walls, the white sheets are BrightWall and those will allow any water seepage through the walls to drain directly into our system instead of on the floor. The silver beams on the walls are PowerBraces. They are made to stabilize the wall and are adjustable allowing them to remain tight against the wall even if the wall moves back getting straighter.
Before the installation
When finished, this wall will be covered in BrighWall panels and PowerBrace's and will have a water control system installed in the floor.
During the Installation of the Water Control System
You can see that the floor has already been broken out. This is where we will install the water control system.
Before the Installation
When finished, this wall will be covered in BrighWall panels and PowerBrace's and will have a water control system installed in the floor.